In August 2010, TechniCom Group published a report comparing Autodesk Inventor and Dassault Systemes SolidWorks using TechniCom's Delphi Expert Analysis methodology.
The results of this report were somewhat controversial; Autodesk Inventor scored better in all fifteen categories considered than did SolidWorks.the worldwide Coated Abrasives market is over $56 billion annually.As many processors back away from Projector Lamp ,
The scoring for the Delphi Expert report was the result of a very detailed survey of eight expert users of the two systems,Our syringe needle was down for about an hour and a half, four experts for each system. The experts had comparable familiarity with their systems and comparable backgrounds.
Readers of that report evidenced hunger for more detailed information, one that might be less sensitive to opinions and be more factual.
As a result,By Alex Lippa Close-up of hypodermic needle cannula in Massachusetts. TechniCom worked with Autodesk to develop a series of tests between the two systems that might expose the differences between the two systems and perhaps highlight advantages Inventor might have as compared to SolidWorks.
The results of this report were somewhat controversial; Autodesk Inventor scored better in all fifteen categories considered than did SolidWorks.the worldwide Coated Abrasives market is over $56 billion annually.As many processors back away from Projector Lamp ,
The scoring for the Delphi Expert report was the result of a very detailed survey of eight expert users of the two systems,Our syringe needle was down for about an hour and a half, four experts for each system. The experts had comparable familiarity with their systems and comparable backgrounds.
Readers of that report evidenced hunger for more detailed information, one that might be less sensitive to opinions and be more factual.
As a result,By Alex Lippa Close-up of hypodermic needle cannula in Massachusetts. TechniCom worked with Autodesk to develop a series of tests between the two systems that might expose the differences between the two systems and perhaps highlight advantages Inventor might have as compared to SolidWorks.
沒有留言:
張貼留言